Share how you modify your Steelbooks here.
Last edited by a moderator:
I've done the same before. Essentially reseated the steelbook shell and it was fine.
Try both shells. When they're off, try laying them flat on their inside side, see if maybe they're not straight.you put the shell back on and it closed properly?, cause i put my front back on and it would still not close properly.
Is that an electrical tape and craft knife job?Thought this could do with some spine treatment.... Turned out well I think!
And now it fits right in....
I'm not too sure about Gimp as I don't use it but I do use Photoshop and it looks to be right on the money for me so long as I print from within Photoshop.View attachment 281462 Hi Folks
Can someone help me out here please as it's driving me nuts.
I got Gimp installed and got the template for the inside from another forum , opened it up with gimp and managed to get all my artwork in properly to the black bits but when I come to print the final image that is printed is way to small for the steelbook.
What am I doing wrong here fellas ?
This is the template I downloaded above.
I don't know what happened but here they are. You'll need to unzip them as they are compressed inside a zip file. If you have Windows 10 it should be able to unzip them.Hello fellas unfortunately the templates in post 2 are offline. Can someone help and upload em again please?
Got some awesome custom printed spines (my design) from a redditor dwbassuk. I can't remember if you're here too, but if you are, thank you:
View attachment 306408 View attachment 306409 View attachment 306410 View attachment 306411 View attachment 306412